日韩 欧美~中文字幕

The full-automatic brick setting machine mainly applies to brick stacking in the once or twice firing tunnel kiln. It is controlled by the electricity and hydraulic lift, it has the characters of energy saving, efficiency, easy maintenance, low cost and stable operation.
 
The full-automatic brick setting machine is formed by moving trestle, clamp plate, separator, lifting guide pillar, rail, hydraulic system and electrical system, etc.
 
The workflow of hydraulic brick setting machine: when the cutter pushes the green bricks to the separating board, the separator starts work, it drives the separating board stretch and separate the bricks. When the brick separating is finished, the lift cylinder turns down. When the clamp plate reaches the pre-set location, the clamp plate fixture picks up the bricks, and then it is lifted to a predetermined height by the lifting cylinder. After all those progress, the separator opens the air duct and the moving device drives brick stacking machine to the top of the kiln car, the kiln car rotates 90°and then lift cylinder drops down to a predetermined height for setting bricks, the clamp plate opens and lays the bricks on the kiln car, it completes stacking process automatically. With the periodical operation the whole stacking work is finished, all these functions are centralized controlled automatically.
Copyright @ 2015-2016 | All Rights Reserved | Zheng Tai Machinery Factory
                                                        
Brick Machine    |   Vacuum Extruder   |   Crusher   |   Brick Setting Machine   |  Brick Production Equipment                          
 
 
日韩 欧美~中文字幕